Installation

1. Schluter-BARIN gutter components are cut to size and attached to the Schluter-BARA profile with the included screws. Elongated slots allow for a slope, if required.
2. To waterproof connections between two gutter sections, center a connector over the seam. The rubber gasket in the connector provides a waterproof seal.
3. To create inside and outside corners, center the corner piece over the seam and secure it in place using two connectors. This process is identical for 90° and 135° corners.
4. To connect a down coupling, an 11-13/16" (20 cm) gutter section with hole and down coupling is centered over the seam and attached using two clip-on connectors.
5. The end caps are held against the gutter from below and fastened with a connector.
6. Screws and elongated slots are concealed by clipping on a cover profile.
7. To complete the project, the corner covers are clipped on.