Installation

1. Select Schluter-BARA-RWL according to the height of the floor construction to be covered. Prefabricated corners and connectors are available for inside and outside corners. Abut the profile ends of Schluter-BARA-RWL, leaving an approx. 3/16" (5 mm) joint. Cover the joint with the clip-on connector.
2. Before the drainage mats (Schluter-TROBA or Schluter-TROBA-PLUS) are installed, set the trapezoid-perforated anchoring leg of the finishing profile, Schluter-BARA-RWL, onto the waterproofing layer and, if required, adjust to the proper height and alignment with dots of mortar.
3. If Schluter-BARA-RWL is used as a gravel edge profile, the gravel layer should abut the vertical profile leg just below the upper lip. The concrete pavers are laid loosely on top of the leveled gravel layer.

Note:
To ensure unobstructed drainage at the edge areas of the covering, make certain during installation that drainage openings in the drainage mat and spaces between the pedestals remain open.