Calculate all you need for your shower project.
Schluter®-KERDI-SHOWER-CB es un panel de compensación disponible para utilizar con KERDI-DRAIN-H, KERDI-DRAIN-A y KERDI-LINE-A en conjunto con los paneles de ducha prefabricados KERDI-SHOWER. Permite la instalación de paneles de ducha en casos en los que no es posible instalarlos directamente sobre el substrato sin interferir con otros componentes. KERDI-SHOWER-CB está hecho de poliestireno expandido ligero y es ideal para construir bases de ducha sin mortero. Está disponible en alturas de perímetro de 1″ (2.5 cm) y 3-1/2″ (8.9 cm), ambas ofrecidas en láminas de 48″ x 24″ (122 cm x 61 cm). El panel de compensación se puede cortar fácilmente a la medida y se puede ajustar alrededor de los componentes del desagüe. Además, se pueden utilizar varios paneles para adecuarse al tamaño y la forma de la ducha.
Podrá encontrar las instrucciones de instalación para el uso de KERDI-SHOWER-CB en el Manual de instalación del sistema de ducha Schluter®.
1. Presente en seco el panel de compensación Schluter®-KERDI-SHOWER-CB y el panel de ducha KERDI-SHOWER. Si es necesario, corte los paneles de ducha y de compensación a la medida. Tome las medidas necesarias para la ubicación del platillo de conexión del desagüe y de la tubería de salida de ABS/PVC.
2. Mark and cut the compensation board for the associated bonding flange opening using the template provided (maximum 5-1/2” (139.7 mm) diameter).
3. For Schluter®-KERDI-DRAIN-H only, mark and cut a 2-3/4" (70 mm) – 3" (76 mm) maximum wide slot for the ABS/PVC outlet pipe. Do not exceed the maximum to ensure proper tile support.
4. Apply Schluter SET®, ALL-SET®, FAST-SET®, or unmodified thin-set mortar to the substrate using a 1/4" x 3/8" (6 mm x 10 mm) square- or U-notched trowel.
5. Place the KERDI-SHOWER-CB compensation board and solidly embed in the mortar.
6. Dry fit the plumbing components to verify the compensation board provides adequate height prior to installing the shower tray.
a. For the 5-1/2” KERDI-DRAIN-A adaptor kits, dry fit the cut compensation board, KERDI-SHOWER tray, adaptor ring, and bonding flange to a fully installed position. If the installed bonding flange is above the shower tray bonding surface by more than 1/8”, additional compensation layer is needed. The bond layers of thin set between boards will compensate for 1/8” or less. Do not exceed 1-1/2” total compensation height to ensure a watertight connection with the rubber gasket below. Suitable materials for compensation are KERDI-BOARD, tile backerboard, water-resistant gypsum backerboard, or polystyrene foam. Do not use wood material over concrete substrate.
7. Continue with installation steps depending on the chosen Schluter drain assembly.
Schluter® Drain Adaptor Kits
How to install the Schluter®-KERDI-LINE-A Adaptor
Schluter®-KERDI-DRAIN-H
How to install Schluter®-KERDI-DRAIN-H & KERDI-SHOWER-CB
Encuentre tutoriales y videos de documentación de proyectos para aprender cómo sacar mejor provecho de nuestros productos, ¡empiece ahora y diviértase!
Ver más vídeos / listas de reproducción