Menu
Schluter®-KERDI-BOARD-ZSD
Schluter®-KERDI-BOARD-ZSD are anchors used to provide additional mechanical attachment of KERDI-BOARD when the bond between the thin-set mortar and the substrate is questionable.
- Appropriate drill bit size: 5/16" (8 mm)
- Drill hole 3/8" (10 mm) deeper than anchor length
- Available in stainless steel or galvanized steel
Schluter®-KERDI-BOARD-ZSD are anchors used to provide additional mechanical attachment of KERDI-BOARD when the bond between the thin-set mortar and the substrate is questionable.
- Appropriate drill bit size: 5/16" (8 mm)
- Drill hole 3/8" (10 mm) deeper than anchor length
- Available in stainless steel or galvanized steel
Configure to Price
Add to
Project Dealer
Locator Product
Table
Project Dealer
Locator Product
Table
Product successfully added to Project List
You can now access your Project List or stay on this page
Go to Project List Continue browsing
Schluter®-KERDI-BOARD-ZSD
Anchors used to stabilize KERDI-BOARD panels
Schluter®-KERDI-BOARD-ZSD are anchors used to provide additional mechanical attachment of KERDI-BOARD when the bond between the thin-set mortar and the substrate is questionable.
Appropriate drill bit size: 8 mm - 5/16" .
Drill hole 10 mm - 3/8" deeper than anchor length.
If the bond between the thin-set mortar and substrate is questionable, additional mechanical attachment with the KERDI-BOARD-ZSD anchors and corresponding screws is required. Fasteners are installed after the thin-set mortar has hardened.
Downloads
Data sheets
- KERDI-BOARD Data Sheet.pdf
- 12.16 MB
Warranties
- KERDI-BOARD-Warranty.pdf
- 0.05 MB
Brochures and Pamphlets
- KERDI-BOARD Brochure.pdf
- 1.44 MB
