Schluter®-SHOWERPROFILE-S
Two-part profile with tapered edge to cover adjoining tile edges
- Features a visible surface of brushed stainless steel and a fleece fabric on the reverse for bonding with the tile adhesive
- Designed to be inserted into the U-shaped groove of the matching hard PVC support profile
- The profile can be used for lateral transitions to the wall or the adjoining floor
- Available in brushed stainless steel
Find recommended accessories here
Shower System Estimator
Calculate all you need for your shower project.
The Schluter®-SHOWERPROFILE-S system profiles represent an elegant solution for finishing the area between the floor and the first course of wall tile in a way that eliminates cutting wedges of tile and ensures a consistent elevation of the first course of wall tile in KERDI-LINE applications. SHOWERPROFILE-S consists of a trapezoid-perforated anchoring leg with a groove, which accepts a tapered brushed stainless steel profile that matches the slope of the KERDI-SHOWER-LT shower tray. The profile is adjusted to cover the exposed wall area and forms the visible surface.
Le profilé Schluter®-SHOWERPROFILE-S ne requiert aucun soin ou entretien particulier et est résistant aux moisissures et aux champignons. Nettoyez le profilé au moyen d'un agent de nettoyage domestique courant. Les surfaces en acier inoxydable exposées aux conditions ambiantes ou à des substances chimiques fortes doivent être nettoyées périodiquement avec un nettoyant domestique doux. Un nettoyage régulier permettra de conserver la belle apparence de l’inox et réduira les risques de corrosion. Les produits de nettoyage utilisés ne doivent en aucun cas contenir d'acide chlorhydrique ou fluorhydrique. Les surfaces d’acier inoxydable deviennent plus lustrées lorsqu’on les nettoie au moyen d’un produit de polissage pour chrome. Évitez d’utiliser des nettoyants abrasifs ou alcalins.
1. Measure the height of the area to be covered at the lowest point. Next, measure the length of the area and mark the profile where it is to be cut at both ends. Remove the protective foil and cut the tapered profile and support section to length.
2. Place the tapered profile into the support section and apply Schluter-SET, Schluter-ALL-SET, Schluter-FAST-SET, or unmodified thin-set mortar to the fleece on the back side of the profile.
3. Press the profile into place and align it flush with the wall tile. Immediately clean away any excess setting material. Install adjacent tiles on the shower base.
Note: The Schluter®-PROCUT-TSM cutting wheel can be used with an angle grinder set to low speed to cut the stainless steel profiles. The SHOWERPROFILE-S support section can be cut with snips. Please read and follow all safety instructions from the grinder manufacturer to prevent injury.
FAQ
How do I cut profiles?
Schluter™ profiles are available in a variety of different materials , so methods for cutting vary. Below are best practices for cutting according...
Read more
Watch & Learn
About the product
Schluter®-KERDI-LINE Grate Assembly & SHOWERPROFILE-S/-R System Profiles
How to order the SHOWERPROFILE-S/-R
Find some existing tutorials and project documentation videos to learn how-to get the best out of our products - for more fun in your life, start now!
Watch more videos / playlists
