Schluter®-DILEX-AHKA
Perfil de media caña para instalación de baldosas sobre superficies ya existentes
- Elimina la necesidad de sellado
- Dispone de un ala de fijación simple perforada en forma trapezoidal que se fija en la capa de mortero adhesivo y un canal ranurado que se adhiere a la superficie del piso.
- Consta de un radio de 3/8" (10 mm) de ancho que previene la entrada de agua y la acumulación de suciedad facilitando la limpieza.
- Ideal para ambientes revestidos con baldosas con altos requerimientos sanitarios, tales como cocinas comerciales, baños y plantas de procesamiento de alimentos
- Hay disponibles esquinas interiores y exteriores de 90° y 135°, conectores y tapones terminales.
- Disponible en varios acabados de aluminio anodizado y con revestimiento de color
Find recommended accessories here
Estimador de perfiles
Descubra lo que necesita para proteger las baldosas y facilitar las transiciones.
Schluter®-DILEX-AHKA is an anodized aluminum, cove-shaped profile for transitions between walls to be tiled and previously finished floors. The profile features a single trapezoid-perforated anchoring leg that is secured in the mortar bond coat and a dovetailed channel, which can be bonded to floor surfaces using Schluter®-KERDI-FIX, epoxy resin, silicone, thin-set mortar, etc. A 3/8" (10 mm) radius cove section forms the visible surface and prevents the accumulation of dirt, making cleaning simple. DILEX-AHKA prevents surface water penetration and meets the maintenance and hygienic requirements of commercial kitchens, bathrooms, and food-processing plants, or any tiled environment where a sanitary cove base is desired. DILEX-AHKA integrates with the DILEX-AHK and Schluter®-RONDEC profiles at 90° inside and outside vertical wall corners, respectively. Accessories for DILEX-AHKA include 90° and 135° inside and outside corners, and end caps.
DILEX-AHKA requires no special maintenance or care and are resistant to mold and fungi. Clean profile using common household cleaning agents. In the case of anodized aluminum and color-coated aluminum do not use abrasive cleaning agents.
1. Select profile according to tile thickness and format.
2. Using a notched trowel, apply thin-set mortar over the area where the trapezoid-perforated anchoring legs will be placed.
Note: If necessary, fill the dovetailed channel of DILEX-AHKA with KERDI-FIX, epoxy resin, silicone, thin-set mortar or similar to adhere the profile to the existing floor surface.
3. Press the perforated anchoring leg(s) of the profile into the mortar.
Note: Install inside and outside corners, connectors, and end caps prior to setting tile. The use of thin-set mortar or similar may be required to achieve a proper fit.
4. Trowel additional thin-set mortar where the tiles are to be installed.
5. Solidly embed the tiles, ensuring full coverage and support of the tile edges, and align flush with the top of the profile, leaving a joint of approximately 1/16" – 1/8" (1.5 - 3 mm) between the tile and the profile.
6. Fill the joints completely with grout or setting material.
Warranties
FAQ
How do I cut profiles?
Schluter™ profiles are available in a variety of different materials , so methods for cutting vary. Below are best practices for cutting according...
Read moreCAD drawings
Specify our products using the
Watch & Learn
About the product
Introduction to Schluter® Profiles
Tips on How to Choose Your Profile Size in Relation to Your Tile
Tips on Cutting Profiles
Find some existing tutorials and project documentation videos to learn how-to get the best out of our products - for more fun in your life, start now!
Watch more videos / playlists
